Got it out to the track finally with the new dash configuration. Bike is throwing a KDS Code 0 engine light. But if I cycle the bike it goes away....
Got them figured out. The sensors were in the wrong channels lol
Hey, I've got a gen 5 zx10r with the AIM MXK10 dash. Bike has kit electronics as well as front and rear potentiometers installed with the...
Looking to purchase a tank extender for 2011+ ZX10R , wondering if anyone has a used one they are willing to part with. Thanks
WTB Evol Technology Triple Clamp offset inserts for my 2016 ZX10R Ideally want the full set 1mm-5mm inserts but mainly looking for the 2mm inserts.
Awesome, thanks for all the information!
No, by higher I meant increasing the front ride height. I played around with a lower front ride height originally but found that the higher front...
Bike has an Ohlins rear shock, I should've been more specific with that last question. I meant it in that if I was to extend the forks would your...
For our Canadian tracks which tend to be very stop and go style, hard braking, sharp turn, hard on gas would you recommend looking into getting...
Are those measurements with cap extenders or internally extended like what was mentioned earlier in the thread? I am not sure what my total shock...
The 6mm measurement was from myself. I've played with the front ride height and going higher made the bike better mid corner. I didn't know you...
Yes, long radius corners make the issue more apparent. I've got 8 turns of pre load on the front and 12 in the rear
Hey all, I recently picked up a 2016 ZX10R and I've been having some issues with setup of the bike that I cant quite seem to pinpoint. The bike...
Separate names with a comma.
