Not sure what happened, but one of the race bikes is shooting error code 21 so I am assuming the wire to the temp sensor got cut. Where is the...
there are very few maps available fort the 05 R6, especially with slidestops etc, so who does good work and whats it going to cost me?
I have a power commander, block off plates, slide stops, K/N filter and a yoshi slipon, should i get a full system, or is it worth it? my last R6...
Building a 2005 R6 race bike but it has a bent frame can I just use a 2003 or 2004? 2005 is hard tro come by.
any one know who does this for less than the cost of a wheel off ebay? need some r6 wheels fixed
ok so i have the opportunity to put this kit cdi and harness off an 02 on my 99, well i did the switch (harness and cdi) and the bikes both start...
i know the harness have switches, but what does it do on a stock harness? where can i get a kit harness?
i need the slot you plug in to that holds the transponder. thanks [email protected]
And where to get them? i have used stockers and gaflers. the gaflers dont seem to work very well.
I am ready to get a cool suit, with all my broken collar bones its hard to get leathers on and off, plus its too damn hot here. Any one have a...
I have a bent fork on my R6 and have a line on a front end from an 04 GSXR 600 with the new radial brakes. is there any way to put it on the R6?...
I have access to a bent up 04 gixxer 600 cheap, but it as a bent frame, can i shove the motor in an older frame? I know the font end will go on,...
01/04 GSXR frame swaps Will the 04 gsxr 600 motor and swingarm go on an 01-03 frame? I am assuming the front end is a no brainer.
Separate names with a comma.
