Any advice on upgrading RD 350 suspension and rims? It's gonna remain a streetbike but if I can swap out the forks and rims I'd be interested....
Thanks for the heads up.
I've been away from the track for long time and my former resources seem to have evaporated. I am looking to get some suspension work done on a...
Hey gang just a note. Check your OnStar account if you have one. Turns out I've been paying double on my account being charged for a vehicle I...
OK, moving from motorcycle to airplane and back and forth. I had to weld a nut onto the rotor to remove it, then I removed the nut by machining...
Thanks for the post. That is the exact problem I had so it sounds like I was on the right path. :) Yes the tanks are tough and difficult to...
Well I got the miserable little SOB apart. What a pain in the ARSE. Now that it is apart.... LET THE FREAKIN MODS BEGIN !!!!!!
Is it true that you can use a 2nd GEN flywheel and mount it to a 1st GEN generator rotor? GEN I flywheel diameter is 120mm, 646g GEN II flywheel...
Of of two things is going to happen. I'm either gonna put some pain on this generator or I'm gonna leave it alone. I haven't decided.
Whew thanks Greg. :)
I'm looking around for reasons not to separate the cases on the SV. What would cause this bluing of the area around the timing chain gear on the...
I truly enjoy endurance racing although I haven't been for a long time. I just don't like footing the bill for everything and doing all the work....
On thinking this over I remember my R6 had virtually no engine braking when I first rode it and I found I had to rely on other methods of getting...
I'm no body guy but I welded some nuts onto an SV tank and it took so much pressure to pull the metal it "tore" the tank. I have a home made...
I curious as to whether or not they help lower lap times. I think they are cool but I've never raced one. Expensive little buggers. :)
Yes I have taken many pictures from angles. Straight on shots don't give enough information. :) I bought a bore scope from Harbor Freight and...
ARMY of DARKNESS "Yo she bitch..... let's go!!" "Whoa.... hey man.... I never seen these assholes before."
I like to buy bikes during the summer. Racers find other bikes they like and sell the one they don't like, or sell one of their back up bikes, or...
I think I used a round file and made notches 180 degrees apart. You only need room for a small punch so you're not removing much metal. Stay away...
I haven't looked at the book but I have .003" end play on the crankshaft and .005" on the clutch shaft. The bearings feel great but I haven't...
Separate names with a comma.