:beer:
send pic to marquesskd at hotmail dot com. Have several sets at the shop. Need any radial mount adapters for them?
"There I was.............." Nice looking work in thse other pics
PM sent
Wednesday and I want to see some motor carnage:Poke:
John Ethell at Jett Tuning saved the day.:beer: FYI The orfice mentioned above. It is approx. 8mm diameter, steel thimble-looking-piece with...
*cricket*cricket*
15351-MFJ-D00 Orfice 1mm. Long story but I have one mising in action. This is the part that fits directly in front of the #3 main journal. Is it...
Usually fits snug, bolts at the front and pressure from the seat holds the rear or the little screws that hold the black side covers. A little...
Dime a dozen here in Germany on the R6 and GSXR. Usually Sebimoto gel coated infested but works and covers dents. A lot of people put duct tape on...
Octoberfest kicking off this weekend also.
http://www.intermot-cologne.com/en/intermot/fuer_besucher/index.php .....and drink the local Kölsch (beer).
+1 from Germany
Per YEC manual "Use only when the A/F diverges with increased vehicle speed" I was definately seeing a different results from the dyno to the...
Bike: 2011 R6 Is there a rule of thumb or advice when it comes to adjusting the "ram air correction". During practice? On the dyno? Currently...
I would like to use the existing room. Been looking at this link. The intake/exhaust set up is crazy!...
Currently the dyno is in a cinder block room 8'H x 10'W x 21'L room. The entrance door is a cheap metal roll up door. I know I need to replace...
Yes, SKU: 162264 This item has been superceded to: 12921-02H01
+1 in Germany
Regardless get Zlock to do the case/bearing mod
Separate names with a comma.