I might have something in the spares pile that works, but if one's readily available I'll buy it. For use with Vortex rearsets. I ordered the DJ 4-130 push/pull sensor if it matters.
Male to Male shift rod B https://www.denniskirk.com/dynojet/male-male-shift-rod-b-32104050.p270928.prd/270928.sku Comes longer than you need, cut down any extra length. Assuming you have the female joint on the shift lever.
Well dammit... last week I tried fitting the sensor and none of the FOURTEEN shift rods I had looked like they would work. So, I ordered the one above and the damn thing is too short with my rearset position (GP shift). Back to the spares box, and found one that was a little longer. Not perfect, but close enough to 90 degrees. Takeaway- just measure what you need then buy the right length rod from here- http://www.fastfromthepast.com/rearsets/rearset-parts/connecting-rods-straight?limit=36