Guys, I installed my power commdr and quickshifter yesterday. I can get the pwr cmdr to work fine, but when I put the cd in for the quick shifter and try to enable the kill time it tells me that there is " no pwr commander connected". On the initial picture of the pwr cmdr that is brought up when the cd is put in, it says Error: connect failed 0. Any ideas? On another thread, one of the guys said the blue and green wires that are inside of the white harness were in the wrong spots. If so where are the correct ones?
You may need the newer version of the shift kill program. What version of firmware is in your PC? What version of the shift kill program? PM me your email addy and I can send you the latest shift kill program.
Matt, my email is [email protected]. I am going to check my pwr cmd firmware when I get home tonight. Thanks for sending that to me! My bike is a Tri 675
I had the exact same problem, I called dynojet and they e-mailed me the updated software and helped me over the phone.