It sounds like the gap between the rad and the rad cap is not closing. The neck that hold the rad cap might be too long. Do you see any repairs in...
Yes thanks, this sounds like good advice. It's time to test different settings, take notes and move on from there.
I took a measurement and I am at 526 or 527 so pretty much there. Ok I need to think this through more. Raising the rear ride height is an option...
Your 525 was from the top of the triple clamp where it meets the fork to the centre of the axle fully extended?
My forks are modified so that they have longer travel than stock so I imagine they are extended. I am thinking I need to reduce my trail. I...
I have been told by a local mechanic/racer that my 600rr would perform a lot better if I bought adjustable triple clamps. Specifically that it...
Yes and thanks!
Hi Guys, Am I correct in thinking that the rebuild kits for this master do not include the seal where this is leaking? If so, can I get parts for...
Hi Everyone, I tried out an r6 master cylinder on my cbr many years ago and enjoyed the feel of the brake. I am thinking about buying a 16x18...
Did this happen right after you took the engine cover off? If so then something did not re-install correctly. There are washers and slots that...
A few mm is not uncommon. That looks like a big difference. Take them out of the forks, measure them from the centre of the hole for the axle to...
When you are testing the shock to see if you performed the work correctly, you need to press down on the shock without the spring. You want to...
Separate names with a comma.