Any advice on upgrading RD 350 suspension and rims? It's gonna remain a streetbike but if I can swap out the forks and rims I'd be interested....
Thanks for the heads up.
I've been away from the track for long time and my former resources seem to have evaporated. I am looking to get some suspension work done on a...
Hey gang just a note. Check your OnStar account if you have one. Turns out I've been paying double on my account being charged for a vehicle I...
OK, moving from motorcycle to airplane and back and forth. I had to weld a nut onto the rotor to remove it, then I removed the nut by machining...
Thanks for the post. That is the exact problem I had so it sounds like I was on the right path. :) Yes the tanks are tough and difficult to...
Well I got the miserable little SOB apart. What a pain in the ARSE. Now that it is apart.... LET THE FREAKIN MODS BEGIN !!!!!!
Is it true that you can use a 2nd GEN flywheel and mount it to a 1st GEN generator rotor? GEN I flywheel diameter is 120mm, 646g GEN II flywheel...
Of of two things is going to happen. I'm either gonna put some pain on this generator or I'm gonna leave it alone. I haven't decided.
Whew thanks Greg. :)
I'm looking around for reasons not to separate the cases on the SV. What would cause this bluing of the area around the timing chain gear on the...
Separate names with a comma.