ruskii
06-17-2009, 04:19 PM
History of the bike:
The bike was originally built by Graves Motorsports for Tommy Aquino. This bike isn’t a street bike that was turned into a race bike; this is a purpose built race bike directly from Yamaha. No expenses have been spared when building this bike. This bike has been raced at WERA Nationals, AMA, and World Supersport! The parts list below is just items I can think of, there are a lot of little trick parts on this bike that make it stand out compared to any other race bikes.
Bike specifications:
2007 Yamaha YZF-R6
Suspension
- Ohlins 25mm cartridges, built by Graves, brand new valving and oil in forks right now.
- Ohlins fully adjustable rear shock, built by Graves to their spec. Brand new oil.
- 2 mm ride height shim.
- Special subframe holes to enable easy shock replacement.
Engine
- Brand new built motor by SLMotorsports (built 06/12/2009)
- Fully ported and polished head
- YEC head gasket
- YEC World Supersport intake camshaft, custom polish
- YEC World Supersport exhaust camshaft, custom polish
- Carrillo H-beam forged rods ($1200 dollars!)
- Crank has been polished and balanced
- Graves emission block-off plates
- Special flywheel
- Clutch washers flattened
- Brand new clutch
- Graves covers
- The whole motor has been blue printed and balanced
- Graves full titanium exhaust system
- Dynojet Powercomander
- Dynojet Quickshifter
- This is one of the fastest 600’s out there and can be competitive at any level.
Chassis
- Engine mount modifications for more flexibility of the frame.
- Graves fully adjustable and folding rear-sets
- Graves SS braided brake lines, front and rear
- Galpher dual carbon brake pads
- Graves clip ons
- Graves brake adjustor
- Graves clutch adjustor
- Graves foldable levers
- Graves fairing mounts
- Graves custom foam seat
- YEC ignition switch
- Graves spec Ohlins steering stabilizer and custom mount
- Graves anti-head shake protectors
- DID EVOERV3 chain
- Renthal 520 sprockets
- Moto-forza carbon reinforced body work from Czech republic
Spares
- Lots of spares
- Sharkskins bodywork
- Case covers
- Levers
- Clipons
- Tanks
- Airbox
- Throttle bodies
- Head
- Rods
- Engine case
- ECU
- Wiring harness
This bike finished 24th out 32 riders in the World Supersport race at MMP. Unfortunately at the trackday after the race, a good friend of mine rode this bike and was taken out by an irresponsible rider. The bike took on a lot of damage. Most of it can be replaced by the spares that I have, however the frame does have a dent in it and the body work isn’t pretty anymore. The bike should run great still and I might be racing it in this condition in the upcoming MoM weekend. I am putting this ad out as a feeler to see if anyone is interested. I willing to sell the bike for $4000 obo. This is a great deal considering I can get more by parting it out on Ebay. If there is no interest in the bike in the next week or so I will probably part it out.
SELLING PRICE $4000 OBO, PLEASE READ THE INFO.
CONTACT at
Oleg.pianykh@gmail.com
Or
801-560-8612
Or
PM me.
The bike was originally built by Graves Motorsports for Tommy Aquino. This bike isn’t a street bike that was turned into a race bike; this is a purpose built race bike directly from Yamaha. No expenses have been spared when building this bike. This bike has been raced at WERA Nationals, AMA, and World Supersport! The parts list below is just items I can think of, there are a lot of little trick parts on this bike that make it stand out compared to any other race bikes.
Bike specifications:
2007 Yamaha YZF-R6
Suspension
- Ohlins 25mm cartridges, built by Graves, brand new valving and oil in forks right now.
- Ohlins fully adjustable rear shock, built by Graves to their spec. Brand new oil.
- 2 mm ride height shim.
- Special subframe holes to enable easy shock replacement.
Engine
- Brand new built motor by SLMotorsports (built 06/12/2009)
- Fully ported and polished head
- YEC head gasket
- YEC World Supersport intake camshaft, custom polish
- YEC World Supersport exhaust camshaft, custom polish
- Carrillo H-beam forged rods ($1200 dollars!)
- Crank has been polished and balanced
- Graves emission block-off plates
- Special flywheel
- Clutch washers flattened
- Brand new clutch
- Graves covers
- The whole motor has been blue printed and balanced
- Graves full titanium exhaust system
- Dynojet Powercomander
- Dynojet Quickshifter
- This is one of the fastest 600’s out there and can be competitive at any level.
Chassis
- Engine mount modifications for more flexibility of the frame.
- Graves fully adjustable and folding rear-sets
- Graves SS braided brake lines, front and rear
- Galpher dual carbon brake pads
- Graves clip ons
- Graves brake adjustor
- Graves clutch adjustor
- Graves foldable levers
- Graves fairing mounts
- Graves custom foam seat
- YEC ignition switch
- Graves spec Ohlins steering stabilizer and custom mount
- Graves anti-head shake protectors
- DID EVOERV3 chain
- Renthal 520 sprockets
- Moto-forza carbon reinforced body work from Czech republic
Spares
- Lots of spares
- Sharkskins bodywork
- Case covers
- Levers
- Clipons
- Tanks
- Airbox
- Throttle bodies
- Head
- Rods
- Engine case
- ECU
- Wiring harness
This bike finished 24th out 32 riders in the World Supersport race at MMP. Unfortunately at the trackday after the race, a good friend of mine rode this bike and was taken out by an irresponsible rider. The bike took on a lot of damage. Most of it can be replaced by the spares that I have, however the frame does have a dent in it and the body work isn’t pretty anymore. The bike should run great still and I might be racing it in this condition in the upcoming MoM weekend. I am putting this ad out as a feeler to see if anyone is interested. I willing to sell the bike for $4000 obo. This is a great deal considering I can get more by parting it out on Ebay. If there is no interest in the bike in the next week or so I will probably part it out.
SELLING PRICE $4000 OBO, PLEASE READ THE INFO.
CONTACT at
Oleg.pianykh@gmail.com
Or
801-560-8612
Or
PM me.