PDA

View Full Version : WTB Dynojet pulltype Quickshifter ASAP

gpstar748
06-01-2009, 10:11 PM
Need a Dynojet Quickshifter "pull" type ASAP
gsxr1000k7
06-01-2009, 10:37 PM
pm sent
Quicktoy
06-01-2009, 10:38 PM
i have 2. one works, one doesnt, i can send them both and just mail me back the one that doesnt work. $100 plus $10 shipping
gpstar748
06-02-2009, 12:12 AM
i have 2. one works, one doesnt, i can send them both and just mail me back the one that doesnt work. $100 plus $10 shipping

if i paypal tonight can you have it sent to me so they arrive by Thursday?

i just found out mine doesnt work while test riding it prior to this race weekend......it worked fine last time i rode :confused:
caboose
06-02-2009, 12:56 PM
if i paypal tonight can you have it sent to me so they arrive by Thursday?

i just found out mine doesnt work while test riding it prior to this race weekend......it worked fine last time i rode :confused:


Before you go spending money, check the wires where they go into the QS housing. I had one of the wires on mine fray and then break just from the motion of normal shifting.

If you've got a busted wire, you can peel off the sticker then dig out the silicone to expose the solder terminals. Remove the old broken wire then feed through more from the outside and resolder with good wire. Fill the little cavity with new silicone then just wrap the QS housing with electrical tape.