WTT - "Pull" Type Quickshifter for "Push"

[Cyrick21]

I am switching my 05 R6 back to standard shift, just couldn’t get used to the whole GP Shift set-up and going back to standard shift.

So wanted to see if anyone had a push type sensor that they wanted to trade for the pull type.

[Cyrick21]

bump....... really not wanting to have to buy another one....lol

[Cyrick21]

bump.... still looking

[rayw1128]

PC or Bazzaz?

[rayw1128]

I meant Dynojet or Bazzaz?

[Cyrick21]

Dynojet...sorry I didn't mention that.

[delacampos]

for standard shift on a 05 R6, you need a "pull". i use a "push" on my R6 with GP shift

[Cyrick21]

U sure??.. I could of sworn when I went and took a look at it to post this thread a month back, I seen it was a pull.....

Hmmm.... I will have to double check that.

[delacampos]

positive! what rearsets you running?

[Cyrick21]

Graves rearsets...

The rod is underneath my shift lever. So when I press down on the lever it pulls on the rod to shift through the gears.

[delacampos]

i'd have to see a pic. i've used Gilles Tooling and now Woodcraft rearsets. for gp shift, it's always been "push".

thinking about it though, did you swap the lever upside down that comes off the shift shaft?

[Cyrick21]

The bike had the rearsets on it when I bought it....

Here is a picture from the thread when I bought the bike.

http://i488.photobucket.com/albums/rr247/noelbry/Allpics131.jpg

[delacampos]

that's a "pull". i'm just used to seeing the silver piece that is connected to to tranny shaft rotated 180 degrees. pic for reference. not my bike but set up exactly the same..

.