fullmetalF4i
10-06-2008, 04:39 PM
My bike will be for sale at the GNF. Ive had a few good seasons on it, but im trying to move to the LWT class next season. I'd like this bike to not be in my trailer coming back sunday
Info on the bike
1995 CBR 600 F3
Bike used to belong to Erion Racing, and has Bill of Sale only
Electronics are the bare essentials for racing. No key, just push the button and go. It does have a starter and battery, but currently the batter loses power. Good for 5 or 6 starts on a charged battery (i just plug it into the battery tender after every race)
All the race essentials
520 chain and sprockets 43 through 46 rears
pro-tek rear sets
clip ons
steel braided lines
currently set up for GP shift but that is easily changed
fox rear shock
hrc black box
Autometer Tach up to 14k
pro-tek gas cap
bike is wired for WERA
swingarm spools
Extras:
1 front wheel w/ dent. Very fixable, there is a guy in Georgia that will do it for like $60, I've got my rain front on there just to put around for points, so it holds air, wheel also has rotors on it
1 rear wheel. The one on the bike has spray painted it silver because it is missing a small piece of rubber that helps hold the spacer in place during reassembly, other than this the wheel is fine and I would consider swapping it onto the bike and usinng the other wheel as a rain rear so you dont have to deal with the spacer ever tire change.
1 rear widened rear wheel. this came on the bike when i bought it. it allowed a 180 rear tire without ballooning it. It was widened by Erion racing (its just a strip welded in) so while it may kinda look like a ghetto job its very well done.
Gas tank (tank on the bike has a dent in the top, still plenty good, but its noted)
extra set of Carbs and extra jets and needles
Clutch plates
2 stock black boxes
some misc stuff as well
looking for $2800 for the whole package, $2300 for just the bike
will be the black 826 w. yellow plates on the pro-pit side.
stop by and check it out or pm me, or cell 352 428 six 48 two
Info on the bike
1995 CBR 600 F3
Bike used to belong to Erion Racing, and has Bill of Sale only
Electronics are the bare essentials for racing. No key, just push the button and go. It does have a starter and battery, but currently the batter loses power. Good for 5 or 6 starts on a charged battery (i just plug it into the battery tender after every race)
All the race essentials
520 chain and sprockets 43 through 46 rears
pro-tek rear sets
clip ons
steel braided lines
currently set up for GP shift but that is easily changed
fox rear shock
hrc black box
Autometer Tach up to 14k
pro-tek gas cap
bike is wired for WERA
swingarm spools
Extras:
1 front wheel w/ dent. Very fixable, there is a guy in Georgia that will do it for like $60, I've got my rain front on there just to put around for points, so it holds air, wheel also has rotors on it
1 rear wheel. The one on the bike has spray painted it silver because it is missing a small piece of rubber that helps hold the spacer in place during reassembly, other than this the wheel is fine and I would consider swapping it onto the bike and usinng the other wheel as a rain rear so you dont have to deal with the spacer ever tire change.
1 rear widened rear wheel. this came on the bike when i bought it. it allowed a 180 rear tire without ballooning it. It was widened by Erion racing (its just a strip welded in) so while it may kinda look like a ghetto job its very well done.
Gas tank (tank on the bike has a dent in the top, still plenty good, but its noted)
extra set of Carbs and extra jets and needles
Clutch plates
2 stock black boxes
some misc stuff as well
looking for $2800 for the whole package, $2300 for just the bike
will be the black 826 w. yellow plates on the pro-pit side.
stop by and check it out or pm me, or cell 352 428 six 48 two