zeus
03-11-2008, 09:56 PM
FS: 1998 Kawasaki ZX-9R with clean and clear title in hand. Bike has about a total of 14,000, but the motor only has about 4,000 miles on it. The bike is set up to be used for both street and track. It has been a track bike mostly for the past 4 years. The motor was built by MD Racing and the frame has been measured and is 100% straight. The only reason for selling the bike is the garage is getting full of bikes and it is not getting rode much.
Motor:
2000 port head
Muzzy big bore kit 1000cc
Balanced crank and rods
Rods strengthened
Trans undercut up shift and down shift
41mm flat slide carbs
Degreed cams
Muzzy Block Off Plates
Factory Pro Billet Case Cover
Motor dyno at 155 hp on pump gas
Motor work alone was over $4,000
After market Parts:
Full Ti Akrapovic with Carbon Fiber Can
Adjustable Attack Triple Tree
Quick Shifter GP Pattern
Penske Triple Adjustable Rear Shock
Race Tech Valved forks with 1.0 Springs
PFM Full Floating Cast Iron Rotors (2 sets) with Billet 6 Pot Calipers
520 Chain with Assorted Sprockets
Daytona Digital Temp Guage
Harris Adjustable Rear Sets
Toby Steering Damper
Woodcraft Clip-ons
1/5 Turn throttle
Shark Skin Bodywork
Spares:
Rear Wheel
$4,500 OBO
http://www.schraderacing.com/gallery319/main.php?g2_itemId=62
http://www.schraderacing.com/gallery319/main.php?g2_itemId=69
http://www.schraderacing.com/gallery319/main.php?g2_itemId=75
Motor:
2000 port head
Muzzy big bore kit 1000cc
Balanced crank and rods
Rods strengthened
Trans undercut up shift and down shift
41mm flat slide carbs
Degreed cams
Muzzy Block Off Plates
Factory Pro Billet Case Cover
Motor dyno at 155 hp on pump gas
Motor work alone was over $4,000
After market Parts:
Full Ti Akrapovic with Carbon Fiber Can
Adjustable Attack Triple Tree
Quick Shifter GP Pattern
Penske Triple Adjustable Rear Shock
Race Tech Valved forks with 1.0 Springs
PFM Full Floating Cast Iron Rotors (2 sets) with Billet 6 Pot Calipers
520 Chain with Assorted Sprockets
Daytona Digital Temp Guage
Harris Adjustable Rear Sets
Toby Steering Damper
Woodcraft Clip-ons
1/5 Turn throttle
Shark Skin Bodywork
Spares:
Rear Wheel
$4,500 OBO
http://www.schraderacing.com/gallery319/main.php?g2_itemId=62
http://www.schraderacing.com/gallery319/main.php?g2_itemId=69
http://www.schraderacing.com/gallery319/main.php?g2_itemId=75