PDA

View Full Version : RaceBodyWork question: What are these things called? Frame Spacer/Bobbin Plugs?

JJHUNSECKER
10-25-2007, 01:21 PM
I've mounted some HotBodies race bodywork on my 07 GSXR 600 and want to finish it right. On the stock bodywork there are a few points that are attached using plastic pointy things that plug into rubber grommets. When installing race fairings is there something that we can get somewhere (where?) that has a bolt head on one end and a point plastic thing on the other so that rubber hole mounting point can be used?

I'm using an improvised bolt with a coupla nuts on the end which works fine but would rather do it right and make it more tidy. What do the big teams do here?

Thanks!
niceracing
10-25-2007, 01:43 PM
I thought with hotbodies you only need to attach at the front upper fairing stay and at the rear of the lower.
JJHUNSECKER
10-25-2007, 01:55 PM
Yeah, I've done that, it's fine, but was just lookin' for the maximum fit. Thanks though...
chipnalong
10-25-2007, 02:33 PM
use 1/4 -20 well nuts . they slide in the factory holes & spread when you tighten them
JJHUNSECKER
10-25-2007, 02:41 PM
NICE!

THAT'S what I'm talkin' about... Ingenuity.

Thanks.